Car Decals Instructions

1- The car must be clean and washed, especially between doors, around the wheels and the wheels.

2- Now the car is washed, you need a NEW Microfiber towel and 70% Isopropyl Alcohol (70% recommended by pro, not more not less).

3- Clean the area were the stripes would be in, by using Microfiber towel and 70% Isopropyl Alcohol (between doors, around the wheels...).

4- Alcohol will remove any left dust and oily things, when you wash the car, please do not use any shining products, cause it have some oily things, and we don't want oily surface!

5- You can install the graphics in wet method, use 2% of baby shampoo in 98% water, you can also install it dry by marking the graphics with masking tape, and do not laying the graphics before you squeegee, cause it haven't air-release feature.

6- Use tape to hold decal in place, Once centered, Add 2 stripes in center for better hold.

7- Use tape on bottom edge to mark where decal will sit.

8- Peel off the back paper and cut it from the center, Spray decal and surface with soap and water if you want to go with wet method, You can install it dry if want, but you have one shot, if it stick, that's it.

8- Level decal with tape marks, and use squeegee to take all water and bubbles out by applying pressure.

9- Remove the center tape and do the same process to the other side.

10- Squeegee the entire graphic, and use a sharp blade to cut between doors and around the wheels.

11- There's an extra vinyl on the edges, The reason for that is to give you a margin to play with it (move it up/down, forward/backward). 3 cm extra vinyl better than short vinyl.

12- Peel transfer tape off gently, leaving decal only. (Always watch decal while peeling off transfer tape).

13- Use heat gun or “Hair dryer” to make vinyl stick on edges and to activate the adhesive.

Demonstration video : https://youtu.be/FvAqluxHQ7Q

Notes:
* If you want to install the graphics in WET method, try to install ONLY the graphics that will go on flat areas/surfaces, and use DRY method to install the graphics on curved areas.

* If you followed these steps literally, I guarantee you that the graphics will last long more than me and you!

* If you not followed these steps, I guarantee you that the graphics will peel off from the 1 week maybe the first day!

* If you followed these steps literally, you clean the Bike right, and you install them right, and they peeled off, then you will get full refund!!

PS: Decals Will NOT stick to ceramic coated surfaces!

- Instructions paper included with the package!

IF You Need More Help, Please Contact Us, We'll Be Very Happy To Help You!